Hi Guys,
I have a Motorola GP399 Model AZH25KCH6AN6 (SW Version R03.14.00 - CP Version R7.01). After searching far and wide for a suitable programming software, I have decided to create a new thread to try and find an updated version of the CPS. Any help is very much appreciated. Thank you in advance!
Kind Regards,
Motorola GP339 Programming Software
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Registered User
- Posts: 116
- Joined: Fri Jan 30, 2015 6:58 am
Motorola GP339 Programming Software
Mitch Baker - VK3GLV
Uniden UBCD396XT, BCT15X, UBCD996T, UBCD436-PT, Tait TM9100, Simoco SRM9000 (VHF + UHF DMAP), Icom IC-2730a, Codan 9323 (Codan 9030 Autotune Antenna), Retevis RT52
Uniden UBCD396XT, BCT15X, UBCD996T, UBCD436-PT, Tait TM9100, Simoco SRM9000 (VHF + UHF DMAP), Icom IC-2730a, Codan 9323 (Codan 9030 Autotune Antenna), Retevis RT52
-
- Registered User
- Posts: 7
- Joined: Mon Oct 12, 2015 5:34 pm
Re: Motorola GP339 Programming Software
I would also be interested in finding this software. The software i have now Motorola Pro GP300/GM300 Series R03.11.16
Error message: Couldn't Open port. Check whether Device/RIB are powered on or not, and the Device to RIB, And the RIB to PC connection is OK
I'm not using a RIB but a usb instead.But when trying to read via the software (R03.11.16) it switches off the radio and gives the above mentioned RIB error. The COM port on the PC and software is the same. Tried Win 10 and 7 and XP.
Error message: Couldn't Open port. Check whether Device/RIB are powered on or not, and the Device to RIB, And the RIB to PC connection is OK
I'm not using a RIB but a usb instead.But when trying to read via the software (R03.11.16) it switches off the radio and gives the above mentioned RIB error. The COM port on the PC and software is the same. Tried Win 10 and 7 and XP.
Ic-400Pro & IC-41W