Good morning all,
I am trying to read a Simoco SRM9000 UW brick with FPPv5.67 using a USB to RJ45 programming lead. However, a short time into the process I am presented with the following error: "Missing Flash Index Table file: FITnnnnnn.BIN". If anyone could please point me in the right direction it would be very much appreciated.
Kind regards,
FPPv5.67 Missing Flash Index File
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Registered User
- Posts: 116
- Joined: Fri Jan 30, 2015 6:58 am
FPPv5.67 Missing Flash Index File
Mitch Baker - VK3GLV
Uniden UBCD396XT, BCT15X, UBCD996T, UBCD436-PT, Tait TM9100, Simoco SRM9000 (VHF + UHF DMAP), Icom IC-2730a, Codan 9323 (Codan 9030 Autotune Antenna), Retevis RT52
Uniden UBCD396XT, BCT15X, UBCD996T, UBCD436-PT, Tait TM9100, Simoco SRM9000 (VHF + UHF DMAP), Icom IC-2730a, Codan 9323 (Codan 9030 Autotune Antenna), Retevis RT52