Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Just new here and have a R6 , I tried to scan some of the bands but all I got was the Adelaide Airport Tower and the
local FM radio Stations ? Do I need to program the frequencies in before and what step sizes do I use ? Are the step
sizes automatic or do I need to program them in. I know I need to read the Manual ? Any help would be welcome.
regards johno0885 23/10/14
What is the general consensus of the R6? I am thinking of getting one in preference to the Uniden UBC-126AT. My budget doesn't stretch to anything digital at this point, so don't want to waste my cash.
Radio enthusiast, ham radio operator and electronics tinkerer.
Given how hard the UBC126AT is to find at the moment, the R6 is a good choice. I recently had one but sold it as a UBCD396XT works better for me. For VHF / UHF scanning, they work well.